Do not place the TP-2.5 next to heat sources such as radiators, stoves or other appliances.
Do not place the TP-2.5 where small children might be able to tamper with the equipment.
If it is not possible to place the preamplifier out of the reach of small children it is
recommended that power cables be removed when the equipment is not in use.
Servicing
Do not attempt to service the TP-2.5 beyond the procedures described in this manual.
For all other service and questions, please contact your authorized VTL dealer or the
factory.
Operational Warnings
It is critical for proper sonic performance of this component that it be
properly configured for the mode of operation while playing.
Always make all connections before powering the TP-2.5 on. Connecting or
disconnecting the TP-2.5 while powered on can damage the unit, and will not be
covered under the warranty. Ensure that no interconnect cables can become loose
during use and that there are no intermittent faults or shorts with the cables.
Do not attempt to disassemble the TP-2.5 chassis or remove any covers
from the unit.
Always consult with your VTL authorized dealer or the VTL
factory before attempting any service work on any VTL unit.
Do not touch the tubes after the TP-2.5 is turned on
. The tubes can get very
hot while the TP-2.5 is operating. Turn off the TP-2.5 and allow the tubes to cool
down before attempting to work with the tubes.
Do not exceed fuse ratings or attempt to bypass any fuses, as this can cause an
extremely hazardous condition and will void any warrantees. Use only the same
type and rating of fuses as specified in the owners’ manual and marked on the
unit.
Do not put shorting plugs into the input jack that is not being used. For
example, if you are using the preamp in MC stage, do not plug the MM
input jack.
TP2.5 Preamplifier Owner’s Manual
VTL
3
