VTL IT-85, Руководство пользователя

Страница: 32 / 38

IT-85 Integrated amplifier
Owner’s Manual
VTL 27
WARNING: For continued protection against fire hazard only replace the
fuse with the same type and rating as was originally specified for the IT-
85. If you have problems locating the correct fuse contact your VTL
dealer or the VTL factory service department.
WARNING Before powering on the IT-85, after
either fuse change, it is extremely important to find
the problem that caused the fuse to blow in the
first place. Consult your dealer or the VTL factory
for service.
Cleaning
Your VTL IT-85 should be dusted occasionally with a damp, non-abrasive cloth. You
should not use any solvents for cleaning the front panel, as this can damage the
lettering and the finish. It is recommended that you use a contact cleaner such as Pro-
Gold on the input and output connectors from time to time. This will ensure optimum
sound and proper signal conducting capability where tarnishing is observed on the
connectors or if the IT-85 is in an environment where corrosion might be a problem.
Use the contact cleaner in accordance with it’s instructions, but under no
circumstances should you allow excess fluid to enter the IT-85, as this fluid is
conductive and could cause you to get a shock or damage the IT-85. Under no
circumstances should any type of abrasives be used on any of the electrical contacts.
Damage to the IT-85 through improper or excessive use of contact cleaners is not
covered under the warranty.
Troubleshooting
1. When I power on the IT-85, Status LED does not come on and
nothing else happens. What should I do?
Check to make sure that the power cord is properly connected to the IT-85
and the AC outlet. Make sure the outlet has power by plugging in another
component. If there is no problem with the power source, check the fuse unit
in the back panel of the IT-85. If the fuse is blown, refer to the “replacing
the fuse” section in this manual. Turn the power on the IT-85 again. If the
problem still persists, contact your authorized VTL dealer immediately.
2. Using the remote control from another stereo component in my system
affects the control of my VTL IT-85. Why is this happening and what
should I do?
Your VTL IT-85 is equipped with a remote control receiver unit that decodes
signals coming from a NEC microcontroller chip with a unique respond code.
If you own another stereo component that comes with a remote control unit