VTech vt9113, Руководство по эксплуатации

Страница: 7 / 16

7
• Press MEM/PROG.
• Press the # key
• Press 0
• Press the MEM key to confirm
Memory Dialing
The VT9113 can store up to 10 different phone numbers that you can dial just by pressing
ON, MEM and one of the number keys (0-9).
Note: if the dialing method is pulse, the digit <#> will be ignored, and the digit <*> will
initial temporary DTMF dialing.
Programming Speed Dial Numbers
The Handset must be OFF.
1. Press MEM/PROG. The ON LED will blink to indicate that you are in the programming
mode.
2. Press the number of the memory location you wish to store the number in (0-9).
3. Using the dial pad, dial the number you want to store. The number can be up to 16
digits long. The number can be entered manually or by using REDIAL.
4. Press MEM to store the phone number to the key you selected.
The phone now exits programming mode and emits a happy tone.
Speed Number Dialing
1.Press ON to get a dial tone.
2.Press MEM and the memory location number key (0-9).
For example, to dial the number you assigned to key '8', you would press ON, MEM, 8.
To Change or Replace a Speed Dial Number
To change or replace a stored number in speed dial memory simply enter the new number
and store it in the memory location you wish to change.
For example, to change the number stored in memory position 7 to 555-1111, you would
press MEM/PROG, 7, 555-1111, MEM.
Storing Pauses in Memory
To insert a pause in a phone number, press REDIAL/PAUSE. The pause is 2 seconds
in length. For longer pauses, press REDIAL/PAUSE two or more times. Each additional
press indicates an additional 2 second pause.
If your phone is connected to a PBX you can store the PBX access number and a pause
before the phone number. For example, to store 9-PAUSE-555-1234 in memory location
8 do the following:
1. Press MEM/PROG
2. Press 8
3. Press 9
4. Press REDIAL / PAUSE
5. Dial 555-1234
6. Press MEM
Using REDIAL
To redial the last number you called, press ON then press REDIAL. The phone will
automatically dial the number.
Storing a Redial Number into Speed Dial
To store the last number you dialed as a Speed Dial number, press MEM/PROG, a location
number (0-9), REDIAL, MEM.
The Page Feature
From the Base Unit, press PAGE to signal the person at the Handset. To end the page
at the base, press PAGE again. To end the page at the Handset, press OFF.
If the Handset is in use ( off hock) when PAGE is pressed on the Base Unit, the Handset
will emit one page alert. If the Handset is not in use (on hook), the page alert will continue
for approximately 60 seconds. This feature is useful in locating a misplaced Handset.
OPERATING INSTRUCTIONS