VTech vt9113, Руководство по эксплуатации

Страница: 6 / 16

6
Making Calls
Pick up the Handset and press ON. When you hear a dial tone, dial the number. The
ON LED will illuminate while the Handset is in use.
If you make a mistake when dialing, press OFF to hang up, then press ON to get the
dial tone again.
You must always press ON before you can dial a call on the Handset.
Answering Calls
When an incoming call is ringing, the IN USE LED on the Base and ON LED on the Handset
will flash.
To answer a call when the Handset is in the Base, just pick up the Handset.
To answer a call when the Handset is away from the Base, just press any key on the
Handset (except OFF). This is very useful in a dark environment; you do not have to
fumble around looking for the ON key to answer the call.
Disconnecting
To end a call, either place the Handset back in the Base, or press OFF on the Handset.
Changing Channels
If you notice interference when using your Handset, press CHAN to switch to a clear
channel. This function is only available when you are on a call.
TONE/PULSE Setting
If you have touch tone service on phone line. Press MEM/PROG, * , *, MEM to switch
to TONE dialing. If you have rotary service, press MEM/PROG, * , # , MEM to switch
to PULSE.
NOTE: Your VT9113 is preset at the factory for TONE dialing.
Temporary Tone
If you have a rotary (dial-pulse) telephone service, (TONE/PULSE setting is set to PULSE),
this feature allows you to enter special codes and tones to operate answering machines,
use electronic banking services, calling cards, or other special services.
First, dial the call normally. Then activate the Temporary Tone feature by pressing TONE
(the * key). You can then press the numbers or symbols you need, and your phone will
send the proper signals.
To end the call, press OFF or place the Handset back in the Base. The phone will automatically
go back to rotary (dial-pulse) service.
Programming The Ringer Type
The Handset ringer is capable of four different types of ringing tones. The following sections
detail how to change the different tones and to turn off a ringer on the Handset.
To program, the Handset must be OFF.
To select a different ringer type do the following:
•
Press MEM/PROG.
• Press the # key.
• Press a key 1,2,3 or 4 to select a ringer type.
• Press the MEM key to confirm.
Turning Off The Ringer
To turn off the ringer on the Handset, do the following:
•
Press MEM/PROG.
• Press the # key
• Press 5 to turn off the ringer
• Press the MEM key to confirm
• To turn the ringer on again, see Programming the Ringer Type.
Checking The Ringer
To check the ringer which is currently programmed, do the following:
OPERATING INSTRUCTIONS