VSpeak VSpeak for JR PROPO, Руководство пользователя

Страница: 4 / 16

JR PROPO, Version: 1.4 www.VSpeak-modell.de
Page 4/12
1.1 Communication
If properly installed, the speech module does not affect the functionality of the transmission
system.
The speech module does NOT interfere with the data exchange, i.e. there is no signal output to
the transmission system. In a way, the speech module "listens" to the HF module, interprets the
data and transfers that as speech as described in the following sections.
2 Speech output
There are 3 types of the speech output:
2.1 Announcement of the sensor values
The start of the announcement of the sensor values is made either by key operation - or timed.
Furthermore the announcements of capacity and altitude can be triggered if an adjustable
difference is exceeded. The corresponding settings are described in section 3.
It is possible to select the announced sensor values individually. Also ALL announcements can
be switched ON / OFF, whereby it can be selected with ON between MIN / current and MAX
- thus the since the last announcement occured MIN / MAX values or at the time of the
announcement actual readings are announced.
Values of non-connected sensors are not announced, even if the setup the relevant
announcement on "ON" position.
The values are announced according to the order in the table in section 3.3.
2.1.1 Altitude Announcement
The data for the announcement of the altitude can come from the altimeter- or GPS sensor. If
you use both, GPS and Altimeter ("or all in one", such as
sm-GPS-Logger ), the altimeter
altitude data are announced.
2.1.2 Speed Announcement
The announcement of the speed data can come from the speed sensor or the GPS. If you use
both GPS and speed sensor, speed sensor data is announced
2.2 Announcements of the alarms
The generation of the alarms is exclusively realised in the "Vspeak module". Therefore it is
possible to stagger alarms by setting different values in the radio and in the "Vspeak module".
For the following values can be set alarm thresholds:

Receiver voltage

Altitude

Cell voltage

Capacity

Voltage power supply
2.2.1 Alarm pause
To prevent a "permanent" active alarm (e.g. receiver voltage < alarm threshold), blocking the
announcement, can the alarm be paused. For this time the alarm message for this sensor value
is suppressed - only after the expiry
and then - still / or again - pending alarm would this be
announced again.