VS Crunch 250, Руководство пользователя

Страница: 8 / 25

VS Security Products LTD ZZ201220, ZZ201222 Page 8 of 25
5.3 Destruction of 2½ ’’ Hard Drives and Solid State Drives (SSD ’ s)
1.
Fit 2 - off Adapter Type B into the Destruction Chamber by sliding them along the guide rails ensuring the T slot is
near the bottom. Pull down the locking latches to secure the guides in place.
2. Ensure the Debris Tray is inserted in the bottom of the Destruction Chamber
3. Place the Hard Drive on top of the Adapters locating it fully within the Destruction Chamber
4. Close the door and ensure it is fully latched
5. Press the green “ Destroy ” button on the right hand side of the display
6. Observe the progress of the destruction cycle in the LCD display
7. When the cycle is complete the “ Open Door ” message shows and the Hard Drive (Or SSD) can be safely
removed from the Destruction Chamber
5.4 Error messages and the Stop / Reverse Button
The Stop / Reverse button is located on the left of the LCD display panel. Instructions and Error Messages are shown in the
display.
Message: “ Incorrect insert or media type ”
After insertion of the media to be destroyed into the Destruction Chamber and the latched closure of the safety door, the
message “ incorrect insert or media type ” will be shown if the item inserted does not fit expected parameters of size or
position, and the Destruction Cycle will not start.
To correct this, open the safety door and check the media type and position and correct as necessary.
Message: “ user pressed stop ”
In the event that the Operator wishes to stop the machine mid - cycle the Stop / Reverse button can be pressed. The
message “ user pressed stop ” will be shown in the LCD. In order to reverse the Crunch 250 to the Start position the Stop /
Reverse button must be pressed for more than 3 seconds and held down until the unit has returned to start. This ensures
the crushing mechanism has been removed from the Media which in turn can now be removed from the Destruction
Chamber.
The Destroy cycle can only be initiated from the Start position.
Message: “ Error – Motor Stalled ” and “ Press and hold Reverse to Reset ”
In the event of a cycle failure due to a stalled motor (jam/stall) (such as may occur if the item in the Destruction Chamber is
not suitable to be crushed) the error message “ Error – Motor Stalled ” is shown, followed by the message “ Press and hold
Reverse to Reset ”
To correct this, the Stop / Reverse button must be pressed for more than 3 seconds and held down until the unit has
returned to start.
Message: “ motor stalled switch off ”
If this message is shown in the LCD the Crunch 250 must be switched off.
The Crunch 250 should then be restarted and the operator should carry out any instructions that are shown in the LCD. If
the message above is repeated and the unit does not reboot correctly switch the machine off and contact technical support.
2½ ” Hard Drive / Solid State Drive (SSD)
Guide Latch
Adapter “ Type B ” with T - slot near bottom