ICON 960 USER MANUAL
VPC
07/15/21
For more information visit vpc.com
ITA MODULE INSTALLATION AND REMOVAL
PART # 410 124 XXX
TOOLS REQUIRED
5/32 Allen Wrench
ITA MODULE INSTALLATION INSTRUCTIONS
1. Remove the handle by removing the 6-32 slotted shoulder screw.
2. Remove the enclosure by loosening the captive screws located at the top
and bottom of the ITA, then gently pulling backwards.
3. Place the module in the ITA until the upper and lower module screws
touch the mating holes in the frame.
4. Using a 5/32 Allen wrench, tighten the top screw while applying light
pressure to the face of the module.
5. Maintain pressure while tightening the bottom screw.
6. Repeat this sequence until the module is seated. Torque the screw to 1.5
in-lbs [0.16 Nm].
7. Reinstall the ITA enclosure. It is important to align the handle correctly.
ITA MODULE REMOVAL INSTRUCTIONS
1. To remove, loosen the top screw 1-2 full turns.
Loosen bottom screw 1-2 full turns.
2. Repeat until the module is separated from the ITA.
NOTE:
For optimum performance and system
longevity, distribute the contact load evenly
throughout the module.
Figure A. Make sure position 1 on the ITA module aligns with
position 1 on the receiver module.
Figure B.
10