Note: The camera will be automatically turned on in Channel 1 when the vehicle
is in reverse condition.
5.
Turn on the monitor. The screen should show the image transmitted from the
camera automatically. If it doesn’t, please refer to the
Pairing Camera(s)
section
to pair the camera with the monitor.
Using the trigger cable
You can use the trigger cable to make the Channel 1 camera display the car rear view
automatically when the reverse gear is engaged.
1.
Connect the ring-shaped connectors to the fuse of the rear gear to trigger the
camera.
2.
Connect the other end of the trigger cable to the monitor.
3.
Turn on the monitor and shift the gear to Reverse.
4.
The screen should show the image of the car rear view automatically. If it doesn’t,
please refer to the
Pairing Camera(s)
section to pair the camera with the monitor.
Note: It is strongly recommended to keep the system in QVGA mode with better
FPS to ensure smooth images. STOP BACKING when [NO SIGNAL] shows on
the monitor.
With battery pack (not included in the package)
1.
Attach the camera to the battery.
Note: If you are not sure which is the positive or negative pole, please try one
way and switch the cables if it doesn’t work. Mixing up the positive and negative
poles won’t damage the camera.
2.
Install the camera and the battery on the vehicle.
3.
Press the power button on the battery pack for seconds to power up the camera.
