13
The Base Unit and the Portable Handset are pre-programmed at the factory to have all the same settings. Do not re-
program the Base Unit unless you change the setting for the Dial Type, Channel Group or the Security Code (see
appropriate topics in the
ADVANCED OPERATIONS & FEATURES
section) on the Portable Handset.
Note:
Voyager has incorporated an efficient way of using the Portable Handset to program the Base Unit. If Dial Type,
Channel Group or the Security Code has been changed on the Portable Handset, the same change(s) have to be made
on the Base Unit or the two will no longer be able to communicate with each other. To avoid any mistakes in re-
programming the Base Unit (if it is done manually), it can only be done through the Portable Handset. The Portable
Handset broadcasts all it’s internal settings to the Base Unit and the Base Unit re-programs itself with these new settings.
You can re-program the Base Unit by:
1. Press
the
button on the Portable Handset.
2. Press
the
button until you reach the
screen.
3. Press
the
button. The Portable Handset will send a signal to the Base Unit to look for a connection.
4. Unplug the power adapter on the Base Unit. Press the “
” button on the Base Unit and while you are
holding it down, plug the power adapter on the Base Unit back in. Release the
program button after one
second.
Note: You must perform step #4 within 30 seconds after pressing the
button (in step #3). If you take
longer than 30 seconds, repeat step #3.
5. When the Portable Handset shows
on the display, the Base Unit will emit a confirmation sound.
Once the re-programming is complete, the system will go into Stand-By mode and you can start using the phone.
INSTALLATION - Registering The Base Unit With The Portable Handset
