Voxelab Aquila Pro, Руководство пользователя

Страница: 28 / 32

26
Trouble Shooting
故障检修
Q：Too much filament oozing?
A：1. Reduce the printing temperature by 5~10℃;
2. Increase the traveling speed, or increase the retraction length and speed.
Q：Unable to resume printing from power failure?
A：It might be caused by different usb flash disk. Make sure you are using the
same usb flash disk before and after the power cut off.
Q：No filament coming out during printing?
A：1. Shorten the retraction length to avoid any abrasion;
2. Check whether the extruder is clogged, use a needle to clean it if
necessary;
3. Confirm whether the filament feeding wheel is stuck, if it is, please clean
it up.
Q：What if offset occurs on the printed model?
A：1. Check the tightness of the synchronous belt and ensure it is correctly
installed;
2. Slice the model again;
3. Reduce print speed;
4. Make sure operating temperature doesn't exceed its assigned set-point
temperature 30℃.
Q：
A：
Printer gets broken at the time of turning it on?
It might be caused by dialing to the wrong voltage. Please check whether
the voltage is dialed correctly.
断电续打功能不能使用。
断电前后使用的U盘不同，请保持断电前后是同一个U盘。
模型打印拉丝严重。
1. 适当调低打印温度5-10℃；
2. 适当调高空走速度，或者提升回抽速度以及回抽值。
模型打印偏移怎么办？
1. 确认同步带张紧力，查看同步带是否安装错误;
2. 打印模型重新切片;
3. 降低打印速度;
4. 确认机器使用环境温度是否超过机器限定最高温度30℃。
机器通电就烧坏了。
开关电源拨码不正确，检查电压是否拨到正确的电压值。
模型打印中不出丝了。
1. 适当调低回抽值，回抽值过大容易磨损;
2. 确认喷头是否堵塞，若堵塞需使用通针清理;
3. 确认送丝轮部分是否卡住，若卡住请清理干净。