Vortice VORT SUPER DRY UV, Инструкция пользователя

Страница: 26 / 48

26
(Fig.23)
Insert the electric cable provided into the appliance
If you would like to change the cable, proceed as follows:
• raise the appliance to a height of at least 250 mm; make
both connections (in the appliance and in the wall) at the
same height, by performing the following tasks:
a. strip the cable
b. connect the cable to the terminals inside the appliance
c. tighten the screws of the terminal board
d. secure the cable by tightening the screws of the cable
gland
(Fig.24)
Install the electric box cover
• Place the cover and secure it with the screws.
• Make sure that the cables are not squashed
(Fig.25)
Secure the appliance
• Gather up the excess cable and insert it into the electric box in the wall.
• Hook the appliance onto the wall panel and make sure it is firmly inserted
on the hooks and lying against the wall.
• Apply the two vandal resistant screws.
NOTE
The appliance must be installed with the vandal resistant screws, otherwise
it may be subject to theft.
(Fig.26)
Install the air filter
Insert the air filter inside the appliance as indicated in Fig. 26, then close
the door, locking the knob.
Install the recovery tank
Insert the tank as shown in Fig. 26
ENGLISH
23
24
26
25