Vortice 22481, Инструкция пользователя

Страница: 9 / 24

9
or animals or damage to property. Vortice Ltd cannot be held responsible in
such cases.
• Since the appliance is double insulated, it does not need to be earthed.
• Check that the current carrying capacity of the mains wiring and socket are
adequate for the maximum rating of the device shown on the rating label. In
case of doubt consult a suitably qualified person.
• When installing the appliance, a multipolar switch must be used. The switch
interpole distance must be no less than 3 mm.
• The appliance is not intended for use by young children or infirm persons
without supervision.
• Young children should be supervised to ensure that they do not play with
the appliance.
Installation for SCNR/M
1° Disassemble back panel (A) and use it to mark the position of the fixing
holes in the wall (Fig. 1).
2° Drill wall and fix back panel (A) by means of two expansion plugs.
3° Insert the cables through the selected back panel (A) knockouts. Leave just
enough free length to enable ease of connection (Fig. 1).
4° Fix to back panel (A) the intermediate cables frame (B) by means of the
special screws (Fig. 1).
Make the connections to terminal box according to wiring diagram (Fig. 2).
Tighten the cables with the screws and cable clamps provided (Fig. 4).
5° When necessary, it is possible to vary the lowest speed by turning the
embodied trimmer with a screwdriver (Fig. 3).
Anticlockwise rotation increases the level of slow speed setting, clockwise
rotation reduces it.
6° Once established the trimmer’s suitable setting, check that the motor starts
regularly.
7° Replace definitively cover (C) and tighten the screws (Fig. 4).
Use (Fig. 5)
a) To start the fan, press button (D) (control lamp lighting).
b) Turn knob (E) to select the desired speed.
c) Adjustable maximum load 450 W.
The control unit is equipped with a 5 x 20 fuse T2, 5A-250V IMQ (Fig. 3).
Installation instructions for SCNR/M + Kit Built-in
(KIT SCB Code 22481)
1° Disassemble the base (A) of the product (Fig. 1).
2° Align and mount on the wall the base (H) of KIT SCB (Fig. 1bis).
3° Insert into the base (H) (after drilling the necessary holes) the leads that
have to be connected to the unit and the power supply, making sure that
the projecting length is suitable to allow the connection of the terminal
boards (Fig. 1bis).
4° Fix the support for the intermediate cables (B) to the base (H) using the
screws provided (Fig. 1bis).
Perform the connection to the terminal board of the regulator following the
diagram provided (Fig. 2bis). Tighten with the screws and cable ties
provided(Fig. 3bis).
5° If required, adjust the minimum speed by moving the in-built trimmer
(Fig. 3) with a screw driver.
Rotate counterclockwise to increase the speed or clockwise to reduce it.
6° After selecting the ideal position of the trimmer, check that the motor is able
to start correctly.
7° Place the cover in its final position (C) and tighten the related screws
(Fig. 3bis).
Use (Fig. 6)
a) To start the fan, press button (D) (control lamp lighting).
b) Turn knob (E) to select the desired speed.
c) Adjustable maximum load 450 W.
The control unit is equipped with a 5 x 20 fuse T2, 5A-250V IMQ (Fig. 3).