VORTEX FACTORY: Via E. Fermi, 5 – 27040 Campospinoso (PV)– ITALY – Tel. +39 0385 765200
VORTEX FACTORY: Via E. Fermi, 5 – 27040 Campospinoso (PV)– ITALY – Tel. +39 0385 765200
OTK KART GROUP srl
Via dei Soprini, 16 – 25080 PREVALLE (Brescia) ITALY-‐Tel. +39 030 6804601 – Fax +39 030 6804698
Rev. 30/09/15
5
17 mm Fixed Wrench
Once chain tension is correct, tighten mount
clamps completely and re-‐check the chain
tension again. Then set the engine stop to just
contact the engine mount, (if provided by the
chassis manufacturer.)
6
5 mm Allen Wrench
Attach the plastic guard bell cover to the
engine by using three
6x20 mm Allen screws.
8
Insert the plastic tube provided on to each one
of the carburettor overflow elbows.
The tube may be provided in one piece only. In
that case, cut the tube in half. The length of
each tube should be 40 cm. approx.
9
Place a recovery tank under the carburettor
and secure it to the chassis by using cable ties.
Make two holes on top of the cap and insert
the free ends of the tubes coming from the
overflow elbows. This container must be able
to vent to atmosphere.
