voptech GoIP, Руководство пользователя

Страница: 51 / 71

51
7. SMS to Email

Outgoing Email Server
(SMTP)

User Name

Password

Forwarding Email
Address
This enables the forwarding of SMS received via the channel selected to a
designated email address.
This specifies the SMTP Server for sending emails.
This specifies the User Name for SMTP Server authentication. Leave this
blank if authentication is not required.
This specifies the Password for SMTP Server authentication. Leave this
blank if authentication is not required.
This specifies the email recipient of the forwarded SMS.
Note: The button is provided to facilitate the programming of each channel. After the parameters
for the CH1 SIM are set, clicking this button automatically duplicates the same settings to all other channels with the exception
that the SMS Client ID is incremented by 1 with respect to the ID of the previous channel.
5.3.14 GSM Carrier
This section sets the mode of the GSM service provider selection mode. The factory default setting is “Auto”
for automatic selection of GSM service provider based on the default preference set by the SIM card.
When a GoIP is installed at a location that is close to a country border, it is possible that the default service
provider is not selected based on the base station signal strength. The GoIP may then register to a GSM
service provider that charges for expensive roaming fees. In order to avoid this, the "Fixed" mode should be
selected in order to lock the channel to a preferred service provider. When the "Fixed" mode is first selected,
you must press [
Save Changes ] to save the setting and then refresh the browser after a few minutes in order
to view a list of GSM service providers. Enter the provider code displayed in the Code entry and then press
[ Save Changes ]. Please view the screen captures below.
5.3.15 GSM Base Station
This feature is intended for advanced users who would like to manipulate the selection of GSM station.
Leave this to the default “Auto” setting if you don’t have any preference. Please wait to allow the device to
register after pressing the
button.