3
UNPACKING INSTRUCTION
CAUTION!
Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the device can be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTION
1. USB
USB input slot.
2. MICROPHONE VOLUME LEVEL
Rotate to adjust the microphone signal volume.
3. MICROPHONE TREBLE
Rotate to increase or lower
the microphone’s higher
frequencies.
4. MICROPHONE BASS
Rotate to
increase or lower the microphone’s lower
frequencies.
5. MICROPHONE INPUT
6.3mm input jack for connecting a microphone.
6. PHONO/LINE
Use this switch to select the input to be sent to the individual
channel.
7. GAIN
Use to set the level of the corresponding input channel.
8. TREBLE
Rotate to increase or lower the high frequencies of the input
channel.
9. MID
Rotate to to increase or lower the middle frequencies of the
input channel.
10. BASS
Rotate to to increase or lower the low frequencies of the input
channel.
11. CUE
Press to select a channel to be listened to via headphones.
12. TALKOVER
Press to automatically lower the volume level of the input
sources when using a microphone (mic priority).
13. PHONE-/MON OUT
Use to change between headphone out or monitor out.
14. CHANNEL VOLUME FADER
Slide to adjust the volume of the corresponding channel.
15. CROSSFADER
Slide to adjust the balance between channel 1 and 2.
16. HEADPHONE OUTPUT
6.3mm headphone stereo jack.
17. MASTER VOLUME
Slide to adjust the volume level of the master-output.
18. VU METER
Indicates the output levels of the left and right master channels.
19. MP3 PLAYER
|<< : Press to restart- or select the previous track.
Play/Pause: Press to (re)start or pause play.
>>|: Press to skip to select the next track.
VOL-: Press to decrease MP3 volume.
VOL+: Press to increase MP3 volume.
EQ: Press to select different effects.
