Volvo XC90 Twin Engine 2019, Руководство пользователя

Страница: 589 / 700

WHEELS AND TYRES
}}
587
16. Read the tyre pressure on the pressure
gauge.
•
If it is below 1.3 bar (19 psi) then the tyre
is insufficiently sealed. The journey should
not be continued. Call roadside assistance
for recovery.
•
If the tyre pressure is higher than 1.3 bar
(19 psi), the tyre must be inflated to the
pressure specified in accordance with the
tyre pressure label on the driver's side
door pillar (1 bar = 100 kPa = 14.5 psi).
Release air using the pressure reducing
valve if the tyre pressure is too high.
WARNING
Check the tyre pressure regularly.
Volvo recommends that the car is driven to the
nearest authorised Volvo workshop for the
replacement/repair of the damaged tyre. Advise
the workshop that the tyre contains sealing fluid.
The sealing fluid bottle and hose must be
replaced after use. Volvo recommends that these
replacements be performed by an authorised
Volvo workshop.
WARNING
Maximum mileage with tyres containing seal-
ing fluid is 200 km (120 miles).
NOTE
The compressor is an electrical device. Follow
local regulations related to waste manage-
ment.
Related information
•
Recommended tyre pressure (p. 569)
•
Emergency puncture repair kit (p. 583)
•
Inflating tyres with the compressor from the
puncture repair kit (p. 587)
Inflating tyres with the compressor
from the puncture repair kit
The car's original tyres can be inflated using the
compressor in the emergency puncture repair
kit.
1. The compressor must be switched off. Make
sure that the switch is in position 0 (Off), and
take out the electrical cable and the air hose.
2. Unscrew the tyre's dust cap and screw in the
air hose's valve connection to the bottom of
the thread on the tyre's air valve.
Check that the pressure reducing valve on
the air hose is fully screwed in.
3. Connect the electrical cable to the closest
12 V socket and start the car.
WARNING
Inhaling car exhaust fumes could result in
danger to life. Never leave the engine running
in sealed areas or areas that lack sufficient
ventilation.
WARNING
Do not leave children in the car without
supervision when the engine is running.
4. Start the compressor by flicking the switch to
position I (On).