10
IMG-254105
Remove the three clips at the upper edge of the side panel and
the four plastic nuts at the lower edge.
Remove the cargo compartment lighting connector.
Lift out the side panel.
Repeat for the other side.
11
IMG-254106
Measure a distance of
30 mm (1 3/16 ")
from the rear edge of
the rear fender and mark out a short line parallel to the rear
edge. Use a piece of tape to make the markings on.
Measure
30 mm (1 3/16 ")
from the rear edge of the gas
cylinder's bracket to the previously drawn line. Mark out the
middle of the hole that is to be drilled where the lines cross each
other.
Pre-drill the hole using a
Ø3 mm (1/8")
bit.
Note!
Use a
5 mm (3/16 ")
drill stop.
Drill out the hole to
Ø8 mm (5/16 ")
and then to
Ø12 mm (15/32
")
to be able to insert the pull screw through for the hole making
tool.
Note!
Do not damage surrounding painted surfaces.
Remove any swarf.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Parking assistance, camera, rear- 31428063 - V1.0
Page 9 / 57