10 Maintenance and servicing
10
}}
333
Removal
Switch off the ignition, remove the remote key
from the ignition slot and wait at least
5 minutes before disconnecting the battery so
that all information in the vehicle's electrical
system can be stored in the control modules.
Open the clips on the front cover and
remove the cover.
Release the rubber molding so that the
rear cover is free.
Remove the rear cover by pulling it away.
Detach the black negative cable.
Detach the red positive cable
Detach the ventilation hose from the
battery
Loosen the screw holding the battery
clamp.
Move the battery to the side and lift it up.
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related
accessories contain lead and lead com-
pounds, chemicals known to the state of
California to cause cancer and reproduc-
tive harm. Wash hands after handling.
Installation
1. Lower the battery into the battery box.
2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Tighten the clamp that secures the bat-
tery.
4. Connect the ventilation hose.
> Be sure that it is correctly connected
to the battery and the vent in the vehi-
cle's body.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See Removal).
8. Reinstall the molding. (See Removal).
9. Reinstall the front cover and secure it with
the clips. (See Removal).
Related information
•
Battery – handling (p. 330)
•
Battery – symbols (p. 330)
Fuses – introduction
The fuses help protect the vehicle's electrical
components from overloading.
There are relay/fuseboxes located in the
engine compartment, the passenger com-
partment and the trunk.
If an electrical component fails to function,
this may be due to a blown fuse. The easiest
way to see if a fuse is blown is to remove it.
To do so:
1. Pull the fuse straight out. If a fuse is diffi-
cult to remove,
a special fuse removal
tool is located on the inside of the
engine compartment fusebox cover
.
2. From the side, examine the curved metal
wire in the fuse to see if it is intact.
If the wire is broken, insert a new fuse of the
same color and amperage (written on the
fuse).
If fuses burn out repeatedly, have the electri-
cal system inspected by a trained and quali-
fied Volvo service technician.
WARNING
Never use metal objects or fuses with
higher amperage than those stated on the
following pages. Doing so could seriously
damage or overload the vehicle's electrical
system.
Содержание 2016 S 80
