35
13. Troubleshooting
With this measuring device, you have purchased a product built to the latest state of the art and operationally safe.
Nevertheless, problems or errors may occur.
For this reason, the following is a description of how you can easily remove possible malfunctions yourself:
Always observe the safety information!
Error
Possible cause
Remedy
The meter cannot be switched
on.
Is the battery dead?
Check the battery condition.
Disconnect and reconnect the battery (per-
form reset).
No correct measured value is
displayed.
Wrong measurement?
Is the sensor flat on the surface?
Check the flat position of the sensor on the
measuring surface.
If required, use the enclosed adhesive
magnet.
The meter cannot be operated.
The hold function is activated
(display “HOLD”).
Deactivate the hold function with the button
“HOLD”.
Undefined system condition.
Disconnect and reconnect the battery (per-
form reset).
Repairs other than those described above must only be carried out by an authorised specialist.
If you have any questions about handling the meter, our technical support is available.
14. Technical Data
Input voltage .....................................................1x 9V block battery (6F22, MN1604 or same build)
Power consumption ..........................................max. 25 mA
Display ..............................................................LC-display, refresh rate: 1s
Measuring frequency of the sensor ..................10 Hz - 10 kHz
Measuring principle ..........................................Piezoelectrical acceleration sensor
Line length sensor cable ...................................approx. 1.9 m
Sensor (Ø x L) ..................................................14 x 30 mm
Sensor prod short (Ø x L) .................................6 x 8.5 mm, 10 Hz - 10 kHz
Sensor prod long (Ø x L) ..................................2 x 38 mm (conical), 10 Hz - 1kHz
