MAINTENANCE AND STORAGE
19
1. Remove the screws from the left panel of the snow thrower.
2. Lift the belt tension and roll the large belt off the big pulley.
3. Replace the large belt by following instructions in reverse order.
1. Allow the engine to cool and clean the snow thrower before storing or transporting. Be sure to secure the
unit while transporting.
2. Disconnect the extension cord from the snow thrower.
3. Inspect the extension cord closely for signs of wear or damage. Replace it if it is worn or damaged.
4. Inspect the snow thrower carefully for worn, loose, or damaged parts. Check connections and screws and
tighten if necessary.
5. Store the unit, along with the disconnected extension cord, in a locked, dry place out of the reach of children
to prevent unauthorized use or damage. Cover loosely with a tarp for added protection.
CAUTION!
This product shall not be discarded with household waste but that it shall be returned to
a collection system which conforms to the European WEEE Directive. Contact your local authorities
or stockist for advice on recycling. It will then be recycled or dismantled in order to reduce the impact
on the environment. Electric and electronic equipment can be hazardous for the environment and for
human health since they contain hazardous substances.
Replacing the Belt
Storage
ENVIRONMENT FRIENDLY DISPOSAL
Fig. 29
NOTE:
Determine the left and right hand sides of the snow thrower by standing behind the unit in the
normal operating position.