7
Problem
Cause
Solution
Motor will not start.
Power plug
• Push plug securely into outlet.
• Try another outlet.
• Check circuit breaker.
• Turn On / Off switch to on ( I )
On / Off switch
• Turn On / Off switch to on ( I )
Vacuum does not
clean carpet or hard
floor.
Dust cup and filters
• Empty dust cup and/or change filters.
• If picking up fine dust, the dust cup may not look full, but
a fine substance tends to reduce suction when it blocks
air flow through the foam filter and filter screen. Refer to
page 2 for filter maintenance. Make sure foam filter, filter
screen and dust cup are installed properly.
Belt
• Replace a worn, cut or out-of-shape belt. Page 4
Hose
• Remove clogs from the hose that restrict the airflow. Make
sure hose is replaced into hose retainer. Page 5
Hard floor setting
• For hard floor cleaning, turn height adjustment knob to
hard floor position. Refer to Quick Start Guide.
Carpet height setting
• For carpet cleaning, turn height adjustment knob to
another position. Refer to Quick Start Guide.
No suction at the
end of hose.
Dust cup and filters
• Empty the dust cup and/or change the filters
• If picking up fine dust, the dust cup may not look full, but
a fine substance tends to reduce suction when it blocks
air flow through the foam filter and filter screen. Refer to
page 2 for filter maintenance. Make sure foam filter, filter
screen and dust cup are installed properly.
Filter screen
• ( Located above the dust cup). Check & clean debris to
maintain full air flow. Page 2
Hose
• Remove clogs from the hose that restrict the airflow. Make
sure hose is replaced into hose retainer. Page 5
Vacuum is hard
to push.
Vacuum height setting
• Adjust knob to a higher position. Refer to Quick Start Guide.
Belt
• Replace a worn, cut or out-of-shape belt. Page 4
Brush roll will not turn.
Belt
• Check brush roll for debris. Page 4
• Replace broken or out-of-shape belt. Page 4
Problem Solving
Make sure vacuum is turned off and power cord is unplugged.
!
