46
Loosen all wheel nuts counterclockwise
about one turn with the socket wrench.
Insert the breaker bar to make full use of
its leverage. Do not yet remove the nuts.
Step 3
Step 4
Step 6
Step 5
Step 7
Only raise the vehicle as much as is
needed to change the wheel.
Do not raise the car until you are sure the
jack is securely engaged.
Provide a firm base for the jack on the
ground. If necessary, use a board. Pas-
sengers should not remain in the car
when the car is jacked up.
Securely insert the jack into the jack port
closest to the wheel to be changed. There
are two jack ports on each side under the
car body for front and rear wheel chang-
ing. Never jack the car up by the bumper
or body.
Fully unscrew the wheel nuts and place
them into the hub cap. take the nut at
the top off last. Place the spare wheel
against the wheel hub and slightly rotate
the wheel until a bolt hole in the wheel is
in line with a threaded bolt in the wheel
hub. Reinstall the nuts and tighten them
crosswise by hand before jacking the car
down.
Raise the vehicle by turning the hex drive
clockwise with socket wrench and breaker
bar.
To lower the vehicle, turn the hex drive
counterclockwise with socket wrench and
breaker bar.
Содержание Campmobile 1973
Страница 1: ...Type 2 Volkswagen Owner s Manual Operation and Maintenance ...
Страница 2: ...Last name First name Initial Street Town State Zip code Area code Tel No Owner ...
Страница 84: ...82 ...
Страница 92: ...USA Typ 2 ...