5
Fixing & Position
The SmartCrystal™ Pro Booster shall be placed on a stable surface and fixed
with 4 screws.
The SmartCrystal ™ Pro Booster should be placed in front of the projector lens.
There is a "Projector Side" label printed on the product that will indicate the
correct direction.
The polarizer of the window should be approximately perpendicular to the
axis of the luminous flux.
It is possible to fix the SmartCrystal Pro™ Booster to the ceiling. In this case it is
necessary to reverse the direction of the frame on its support (see "7.4
Installing in Ceiling" section).
Connections
Once started, no cable should be connected or disconnected from SmartCrystal Pro
™ Booster.
Before making any changes of the wiring configuration, it is essential to wait for a
complete shutdown of the SmartCrystal Pro ™ Booster using the ON / OFF button and
checking the LCD.
The first SmartCrystal Booster Pro ™ are delivered with a WiFi dongle connected to
one of its USB ports. The new devices have this WiFi dongle directly integrated in the
electronic board.
For the proper functioning of the product, it is essential to never disconnect the WiFi
dongle.
Connect the sync cable (BNC-BNC, BNC-3 pin MiniDIN) between the 3D sync
output on the projector and the 3D Sync Connector on the SmartCrystal™ Pro
Booster.
Plug-in the power cable and the Ethernet cable if necessary to SmartCrystal™
Pro Booster.
Turn the switch to ON.
Starting
After switching on the product an initialization phase of SmartCrystal™ Pro
Booster will commence which may last a few seconds. Thereafter, the system
will recognize the 3D synchronization and start operation automatically. The
SmartCrystal Pro ™ Booster settings can be optimized directly on the touch
screen. By briefly pressing one of the parameters, it is possible to access the
setup window for the given parameter.
