SmartCrystal™ Diamond
n ° : MUV140036
Version : A12
USER MANUAL
Date : 11/01/2018
www.volfoni.com
This document is the property of the Co VOLFONI and may not be reproduced or disclosed without permission.
35
Adjust the position (height, angle) of the SmartCrystal™ Diamond Box in relation to the beam light from the projector using the
graduations on the sides of the SmartCrystal™ Diamond Box.
To fit this, use the carriage adjustment units of the bracket
The ideal position is when the beam light is centered at the inflow and at the outflow of the SCD Box, as mentioned by the figures
below.
- This step might alter slightly the position of the SCD Box in relation to the projector lens. Check again (removal/bringing close) by
making the carriage slide:
- There must be no contact between the device and the projector (lens included).
The SmartCrystal™ Diamond Box must be as close as possible to the projector lens without touching it, i.e. less than 2cm.
Fit in the bracket again if necessary.
If you alter one of the adjustments (position or orientation), you systematically need to carry out all the checks and repeat the
process as many times as necessary. If you have respected the procedure, one iteration should be enough.
As the position and the orientation are satisfying, the SCD Box is installed.
Fig 20
