U
SER
M
ANUAL
©
VOI
SPEED
L
TD
.
10
5 -
Basic operations
5.1 -
Manual configuration
It is possible to send commands to the V-6016 adapter by entering a sequence of keys on
the keypad of the device connected to the adapter. The list of commands is reported in
the table below:
As default, once connected to the network, the device requests a valid IP address to the
DHCP server. It is possible to verify this IP address by typing #*111#. In case the
recorded message provides a null address (0.0.0.0) it means that the procedure has been
unsuccessful. In this case you will first need to enter the command #*100# (to allocate the
standard IP address 102.168.1.179). On a web browser, you will then need to access the
following web page to reconfigure the system: http://192.168.1.179/
6 -
Configuration using the web interface
It is possible to display the web interface by accessing the following web-page on a web
browser:
http://IP_ADDRESS/
The IP address is the address of the V-6016 adapter. This address is generally allocated
by the DHCP server. Alternatively, you need to associate a static IP address to the
adapter.
Keys
Description
#****#
Restarts the adapter.
#*000#
Resets network configuration.
#*100#
Setup a static IP address (default
address: 192.168.1.179.)
#*101#
Requests an IP address from the
DHCP server.
#*111#
A recorded message will notify the
adapter’s IP address.
#50+IP#
Manual configuration of the adapter’s
IP address (with * as a separator). For
example to configure 192.168.0.113
you will need to enter:
#50192*168*0*113#
#51+IP#
Manual configuration of the Gateway’s
IP address (as above).
#52+IP#
Manual configuration of the primary
DNS IP address (as above).
#53+NETMASK#
To setup the Sub-net mask.