![background image](http://html.mh-extra.com/html/extron-electronics/pvt-hd-rgb/pvt-hd-rgb_installation-manuals_2455074001.webp)
IMPO
RTAN
T:
Go to www.extron.com for the
complete system installation guide,
instructions, and specifications.
PVT HD RGB
•
Installation Guide
The Extron
®
PVT HD RGB is a
2-gang AV wallplate for PoleVault
®
, PlenumVault
®
, and
WallVault
®
Systems that support the PVS 407D switcher.
It passes HDMI/DVI, high-resolution computer video, and
analog stereo audio signals to a PoleVault digital switcher
up to 150 feet away over shielded twisted pair (XTP DTP 24)
cable.
The PVT has one HDMI connector and an audio input jack
on the left front panel, and on the right front panel it has one
audio input jack and one 15-pin HD VGA connector for RGB
input signals.
NOTE:
This device is compatible only with the PVS 407D, running firmware version
4.00 or above. It is not compatible with the PVS 405D or other XTP/DTP devices.
VGA IN
HDMI IN
AUDIO IN
AUDIO IN
Installation
ATTENTION:
•
Installation and service must be performed by authorized personnel.
•
L’installation et l’entretien doivent être effectuéspar le personnel autorisé
uniquement.
•
The unit must be installed in accordance with the National Electrical Code and with
local electrical and safety codes.
•
L’unité doit être installée conformément au National Electric Code.
NOTES:
•
Install the wallplate directly into the wall using the supplied mud ring or a UL
Listed 2-gang junction box (not supplied) such as a RACO 232, following the
steps below.
•
If installing a junction box, allow enough depth for the wallplate and cables. Take
into consideration the bend radius of the cable, providing suitable strain relief
and maintaining the cable bend. Do not bend the cables 90 degrees.
•
Conduits and conduit adapters should be used.
•
Use a wall box with a depth of at least 3.0 inches (7.6 cm). Alternatively, the
included mud ring (MR 200) can be used.
1.
Using the mud ring or a junction box
as a guide, mark the edges and cut out
the material within the marked area of
the mounting location.
2.
Either:
•
Insert the mud ring into the opening,
rotate the locking arms, and secure it
with the supplied screws,
or
•
Insert the wall box and secure it with
nails or screws.
VGA IN
HDMI
IN
AUD
IO
IN
AUD
IO
IN
Faceplate
Wall
Mud Ring
Extron
®
PVT HD RGB
STP cable
from PoleVault
®
Switcher