PFW 6858
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
7
1
1.
Insert one (1) 5/16" x 3" lag bolt and one (1) 5/16"
washer into each pilot holes.
2.
Tighten all lag bolts using a socket wrench and
1/2" socket.
Two people are recommended for this step: one
person to level the wall mount and another person to
mark the mounting locations.
Concrete Installation
2
3
Drill four (4) pilot holes of each mark using a drill and
3/8" masonry drill bit.
Insert the Finned Anchors into each pilot hole.
Lightly tap each Finned Anchors into place with a
hammer.
Do not over tighten the lag bolt.
www.vogels.com | Europe +31 (0)40 26 47 400
Page 5
PFW 6858
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
7
1
1.
Insert one (1) 5/16" x 3" lag bolt and one (1) 5/16"
washer into each pilot holes.
2.
Tighten all lag bolts using a socket wrench and
1/2" socket.
Two people are recommended for this step: one
person to level the wall mount and another person to
mark the mounting locations.
Concrete Installation
2
3
Drill four (4) pilot holes of each mark using a drill and
3/8" masonry drill bit.
Insert the Finned Anchors into each pilot hole.
Lightly tap each Finned Anchors into place with a
hammer.
Do not over tighten the lag bolt.
www.vogels.com | Europe +31 (0)40 26 47 400
Page 5
PFW 6858
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
4
1. Insert one (1) 5/16" x 3" Lag Bolt and one
(1) 5/16" washer into each pilot holes.
2. Tighten all lag bolts using a socket wrench and
1/2" socket.
Do not over tighten the lag bolt.
1)
Insert a small straw or toothpick into the threaded inserts found on the
back of the flat-panel.
2)
Use a pencil to mark the depth of the threaded insert on the small straw
or toothpick.
3)
Mark the straw or toothpick 1/8” above the depth of the threaded insert,
as shown in Figure 1.
4)
Insert the small straw or toothpick into the remaining threaded inserts
to compare and verify their depth using the straw or toothpick’s 1/8”
allowance mark.
5)
Locate the correct diameter screw for the threaded insert.
If the screw you selected is longer than the 1/8” allowance mark on
the small straw or toothpick, as shown in Figure 2 and Figure 3, do
not use this screw. The screw length must not bypass the mark.
6) Test each size of the screws provided.
The correct screws should thread easily into themounting point and
not pull out when tension is applied.
Small Straw or Toothpick
Marking the 1/8”
Allowance
Small Straw
or Toothpick
Small Straw
or Toothpick
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
Selecting the Mounting Hardware
www.vogels.com | Europe +31 (0)40 26 47 400
Page 6
