background image

MM-060

REV00-0825015

1 of 3

Installation Guide

Universal Wall Mount

Before beginning the installation process, fi rst determine if the mount 
will attach to the rear or the bottom panel of the speaker then select the 
corresponding instructions below:

Rear Mounted Confi guration
Assemble the Pivot U-Bracket to the set of holes closest to the bracket pivot 
using the supplied ¼-20 x5” long screws.

Bottom Mounted Confi guration
Assemble the Pivot U-Bracket to the set of holes farthest from the bracket 
pivot using the supplied ¼-20 x5” long screws.

Step 1: Assemble Tilt Mechanism
Assemble the free end of the threaded pivot bar to the Pivot-U-bracket using 
the supplied fl at head screws and tighten (Figure 3).

Step 2a: Install Wall Plate to Wall
Orient the wall plate with the smaller through hole under the larger hole and 
place over the desired wall location. Using a level, mark the mounting holes, 
then pre-drill the holes using an undersized drill bit.

Secure the Wall Plate to the wall using the appropriate mounting hardware.

DO NOT INVERT THE WALL PLATE. THE TAB MUST ALWAYS BE ON 
THE TOP SIDE.

Caution - If in doubt, consult a hardware specialist in the proper selection 
for mounting  to the structure (Figure 4). If wiring is coming out from the wall, 
make sure that it is long enough to go out from the square hole of the wall 
mount plate.

The versatile MultiMount™ MM-060 wall mounts loudspeakers weighing up to 
60 lbs to walls using the standard four-hole mounting patterns located on both 
the back and the bottom panels. 

The MM-060 simplifi es and speeds up installation while off ering a very 
versatile range of mounting and aiming options. 

Note to installers

Due to the wide variety of wall structures, materials and mounting 
methods, these instructions assume that the installing contractor will 
exercise proper judgment in selecting the mounting area and hardware.

As a guide, the installation, when complete should be capable of 
supporting 5 to 10 times the actual applied load. Also, always use a back 
up safety system such as a safety cable.

To assure a trouble free installation, read through and follow these 
instructions carefully before beginning. If you have doubts about 
the integrity of the structure you are mounting to or you are not 
sure about the proper hardware to use, consult a structural and/or 
hardware specialist. 

Be sure that all of the following items are included in this kit before proceeding:

1 pc     Wall mounting plate 

1 pc     Speaker adapter assembly

1 pc     Hardware kit 

1 pc     Instruction sheet

Note: Screws and washers to attach speaker to adapter plate are not included

Rear Mounted Confi guration

Bottom Mounted Confi guration

Отзывы: