MM-060
ALWAYS INSTALL SAFETY CABLES
WARNING: Mounting and/or suspension loudspeakers requires experienced
professionals. Improperly installed loudspeakers can result in property
damage, personal injury and/or liability to the installing contractor.
Adaptive Technologies Group
1635 E. Burnett Street | Signal Hill, CA 90755 USA
Ph: 562.424.1100 | Fax: 562.424.3520
www.adapttechgroup.com
REV00-08252015
2 of 3
Installation Guide
Universal Wall Mount
Step 2b: Install Wall Plate to Stud Bridge Plate
Select the optional Stud Bridge Plate (WP-16) to bridge between two structural
wall studs. Install the Stud Plate with the two closer studs oriented on the lower
end of the plate. Secure the Wall Plate directly to the protruding threaded studs
using the provided fl at washers and nuts (Figure 5).
Step 3: Attach Mount to Speaker
Attach the speaker mount to the selected speaker mounting holes using the
speaker manufacturer’s recommended or supplied hardware (Not included with
the mount). Tighten these fasteners permanently (Figure 6 and Figure 7).
Note:
If the speaker cabinet does not offer threaded mounting holes, do not install this
mount. Consult the speaker manufacturer for their recommended mounting procedures.
Step 4: Prepare the Wall Plate
Insert the ¼-20x 1.75” screw through the lower hole of the wall mounting
plate. This will act as a landing for the support arm (Figure 8).
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
