www.voestalpine.com/strassensicherheit
voestalpine Krems Finaltechnik GmbH
ONE STEP AHEAD.
Assembly instructions KB 1 RH3 on pile-drivable subgrade
page 9 of 13
The carriageway facing the respective slide profiles in the joint region (upper part) is
indicated by the stamped plate marked with
⌂
on voestalpine crash barriers. The
sliding profile joint is to be aligned, as seen from the direction of travel ~180 mm after
the post axis and secured in place with three coach bolts M16x35 FK 4.6, washers
40x18x4 and nuts M16 FK 5 (see Fig. 3).
6.
Mounting the "round damping element" (round damper)
The round damper is to be bolted in place to the V140 post section with two hexagon
bolts M10x25 FK 4.6. The two keyholes in the round damper must align with the two
elongated holes 18x36 mm on the front face of the post section (see Fig. 1). The
hexagon bolts M10x25 FK 4.6 are inserted through the pre-mounted washer 11 from
the round damper, through the narrow side of the axially positioned keyhole (narrow
side up) and the elongated holes (see Fig. 4). A gusset plate 120x50x2 with two
axially aligned bore holes 12 mm diameter is placed onto the two bolts M10x25 FK
4.6 on the inner side of the post and fixed in place with two hexagon nuts M10 FK 5
(see Fig. 5).
Figure 5
Figure 4
