Vodavi Starplus DHS, Техническое руководство

Страница: 70 / 338

DHS Installation 2-47
At any executive station:
1. [FEAT] + [#] + [
*
] + [
000000
] (default password)
2. Press [SHOW]
3. Press [NEXT ] until RESOURCE displays
4. Press [SHOW]
5. Press [NEXT ] until RMT X RATE displays
6. Press [CHG] until 1200
7. Press [CLEAR] to exit programming.
11. External Paging Equipment (Optional)
The system provides a one way paging output at the KSU from the Option Module when
installed. An 1/8 in. phono jack (refer to
Figure 2-25 ) labeled J3 EXT PAGE is provided for
connection to an external paging amplifier. The input specifications for the external
paging equipment should accept a 600 ohm and 0 dBm interface.
Figure 2-25: 1/8 in. Phono Jack
Installation
Install the external paging equipment as follows:
1. Cut a length of shielded cable to run from the amplifier to the KSU.
2. Attach a 1/8 in. male phono plug to one end of the cable.
3. Connect the other end of the cable to the high impedance input according to the
manufacturer’s instructions.
4. Connect the paging speaker(s) to the amplifier using speaker cable.
5. Plug in the amplifier's AC power cord. ( DO NOT use the same AC outlet being used for
the KSU).
6. Insert the 1/8 in. phono plug into the jack labeled EXT. PAGE located on the bottom
edge of the installed Option Module. The Ext. Page phono jack on the Option Module
is the center-right phono plug (refer to
Figure 2-26: External Paging Equipment
Installation ).
7. Set the paging amplifier's volume control to the lowest setting and turn ON the
external amplifier.
8. From a station location, make a page by lifting the handset, and dialing [F] + [501],
the external page feature code.
9. Adjust the amplifier to the desired level while announcing the page.
10. PAGE VOL may be adjusted to lower the output signal in the event it is to strong for
the connected amplifier input (over-driving input).