VocoPro CDG-7000RV, Руководство пользователя

Страница: 12 / 24

12
Getting Connected
Connecting Speakers
The Speaker Terminals are located on the rear panel .
There are two SPEAKER terminals . Be sure to connect the
left channel (L), right channel (R), “+” (red) and “--” (black)
properly .
CDG-7000 rear panel
• Before connecting the speakers, make sure that the CDG-
7000RV is disconnected from the power source .
• Do not let the bare speaker wires touch each other or
another metal part of this unit . This could damage the
CDG-7000RV and/or the speakers .
Determining the proper way to connect the speaker
cables:
The speaker cable is a pair of insulated cables running side
by side . One cable is colored or shaped differently , perhaps
with a stripe, groove or ridges .
1 . Connect one end of the striped (grooved, ridged, etc .)
cable to the “+” (red) terminal on the rear panel of the
CDG-7000RV .
2 . Connect the other end of the striped (grooved, ridged,
etc .) cable to the “+” (red) terminal on the speaker .
3 . Connect one end of the “plain” (NO stripes, grooves,
ridges, etc .) cable to the “--” (black) terminal on the rear
panel of the CDG-7000RV .
4 . Connect the other end of the “plain” (NO stripes, grooves,
ridges, etc .) cable to the “--” (black) terminal on the
speaker
speaker wires
CDG-7000RV
connectors
Preparing the Speaker Cable
You can either use an exposed speaker wire or Banana Plug
speaker cable .
Exposed Speaker Wire
1 . Remove approximately 3/8” (10mm) of insulation
10mm
2 . Twist the exposed wires together to prevent short circuits
3 . Loosen the knob on the speaker terminal
4 . Insert the bare wire
5 . Tighten the knob until the wire is secure
3 4 5
Banana Connector