Vocality V200, Руководство пользователя

Страница: 48 / 114

Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Page 38 of 114
Figure 5-2 ASCII setup
5.1.3 Technique
You will need to start at the Banner page on M&C interface and enter the commands
below. (Replace nodename by the node name of the unit, not the node ID.)
1. Enter TTY mode by typing <Ctrl> <E> then <Ctrl>
tt
.
2. To list all the settings type a command with the form ' nodename
?
', for instance
remote1 ?
<Return> (If you do not know the nodename just use the word
nodename
.)
3. To capture the settings type a command with the form ' nodename
?
' Do not
press <Return> yet. Start a capture file (see below) and then press <Return> ,
this will copy your entire configuration to file.
4. Stop the capture.
To start a capture file in HyperTerminal:

Select from the top menu bar Transfer > Capture Text .

Select a place to store the file and a name for it. Press Start .
To stop a capture in HyperTerminal:

Select from the top menu bar Transfer > Capture Text > Stop
To start a capture file in PuTTYtel:

Alter your set up by choosing the Logging tab and check Session Logging:
'Printable Output'

Specify a name and location to save the resulting text file.
 Return to the Session tab and press Save . Then start your session as usual.
To stop a capture in PuTTYtel:

Close your session

Reverse your setup changes by checking Session Logging: 'None'