Vocality V200, Руководство пользователя

Страница: 31 / 114

Vocality User Manual
User Manual for V200
Valid for V08_08.02 or V08_48.02
Page 21 of 114
appear.
When you are ready
to make your changes permanent select
Save Validated Changes.
At any point you can
select Cancel Changes to discard the
changes you were making.
<Enter> .
To leave a menu press <Esc> . You may be
asked if you want to save the changes you
made to the menu you are leaving.
Return to the banner page at any time by
entering
<Ctrl><E> .
4.1 Port Addressing Scheme
Throughout the configuration of the Vocality multiplexer/router products, references
are made to nodes, bays, slots and port numbers in the network. By convention, the
addressing syntax used is
Node : Slot : Channel , where Node is the Node ID, Slot refers to a
logical grouping of ports, often on the chassis or a particular card and Channel refers to
a specific port within a slot. This scheme is adapted to the physical arrangement of each
unit, see pictures in
Section 4.1.2 . (This naming scheme applies only to multiplexer
ports, not the Ethernet ports.)
4.1.1 Node ID
The most important item in the unit’s configuration is the Node ID. This is a unique
number between 0 and 999 (however 240-255 are reserved) which specifies each unit in
the network and you must program this before anything else. This is done on the
System menu .
You should restart the unit when you have set the Node ID. This will clear previous
routing information and allow the unit to assume the new identity without confusion.
Note: When a unit is configured as a Push Config client , the Node ID is set via the
Push Config Clients menu by the hub unit.
4.1.2 Slot and Channel Numbers
From the rear, the V200 is laid out as follows:
Figure 4-4 Bays on V200