G406L User Guide Document: G406L-2
----------------------------------------------------------------------------------------------------------------------------- ----------------
26
➢
If the image is at portrait position, this function is only available under input signal up to 4k/2k
@30Hz.
➢
If Video Wall [Zoom] is set to H=2 & V=2 or above, user can apply 4k/2k @60Hz input signal. The
adjustment range (1800 pixels) is calculated based on signal source resolution.
➢
When user adjusts Overlap value in one monitor, it will also change the scaling factor. User needs
to adjust the Overlap value in other monitors to let all monitors has the same scaling factor.
➢
The
adjustment range of 1800 pixels is calculated according to the signal source resolution. If the
signal source is 1080p and the adjustment value is 450 pixels, when switching to 4k/2k input
signal, the adjustment value will be converted to 900 pixels automatically to maintain the same
image position.
If the input signal source is 1080p and the adjustment value is 1800 pixels
(maximum), when switching to the 4k/2k input signal, the adjustment value will be kept at 1800
pixels (it should be double but the maximum is only up to 1800 pixels), and the image position will
be not the same as 1080p.
15. PC tool
➢
Each G406L has independent IP address. The default IP address is 192.168.0.100. User can set
different IP address in each G406L and control multiple units of G406L at the same time.
➢
Two PC tool is available for the control of GeoBox:
✓
WebGui: embedded inside G406L. No additional software is required.
✓
UHDWall Manager (UWM): HID PC tool, can be used through USB or Ethernet connection
without installation process.
15.1. WebGui
➢
WebGui is embedded inside G406L. Once user connects G406L with PC through Ethernet, user can
access WebGui and execute all operation similar to OSD menu through Virtual Keys and OSD Menu.
No PC or appropriate software tool is required.
➢
User can turn on/off the system through WebGui and see the status through power indicator.
➢
WebGui can be controller through mobile phone. Please note that iPhone may have different behavior
and cause some mistake.
➢
In WebGui operation, the icon in the slide bar may need to move to middle point to take effect.
