G406L User Guide Document: G406L-2
----------------------------------------------------------------------------------------------------------------------------- ----------------
10
➢
If continuous flashing in Power key LED
at 0.5” interval, it means the OSD function has been
Locked. Please press [Menu] key for 5 seconds to disable [OSD Locked] function. If user sets menu
lock through remote controller, the Power key LED will be
flushing at 1.0” interval. User needs to
press number keys [850] to disable menu lock.
➢
Output resolution list: 1024x768 60/120Hz, 1280x720 60/120Hz, 1280x800 60/120Hz, 1280x1024
60Hz, 1360x768 60Hz, 1400x1050 60hz, 1600x1200 60Hz, 1920x1080 24/30/50/60Hz, 1920x1200
30/60Hz, 2048x1080 60Hz, 2048x1200 60Hz & Deep Color.
➢
All output resolution is RGB 4:4:4 and progressive. If the input source and display device can
support 10-bit color, user can turn on [Deep Color] to display 10-bits color. User can click [INFO]
key to check input / output result.
➢
User can set EDID to tell input source to output desired resolution. User may need select from PC
Display Control Panel to set output resolution again or to re-boot PC to output EDID resolution.
➢
G406L can support non-VESA standard input timing once signal source can provide, such as
7680x1200 @30Hz or 2400x2400 @60Hz.
➢
When press [OTH] key to select output resolution, the monitor will resynchronize the timing and it
will take few seconds to finish the selection.
➢
User can click [INFO] key to get system information and see input / output signal resolution.
➢
The input refresh rate should be the same as output refresh rate so that the system can implement
Frame Lock to synchronize all the outputs. If the input source is 50Hz with 60Hz output, then it is
possible to see some synchronization issue among the displays.
➢
User can select output resolution from remote controller. When press [OTH] key, it will show
resolution of 1920x1200, 1280x720 and 1360x768 continuously. After release from keypad, the
system will apply the selected resolution to the selected output port.
➢
User can also get into OSD menu to do output resolution settings: [Image Properties]
→
[ Output
Mode]
→
Select output resolution
➢
Input green LED will light up when each processing module has detected input signal.
➢
Green LED will light up when G406L has detected the monitor in each output.
➢
Power LED:
✓
Red: Power connected
✓
Green: Power on
✓
Red flashing at 0.5
” interval: OSD lock through Menu key
✓
Red flashing at 1.0
” interval: Box ID lock through remote controller 85x ID # control key
7. Set 10-bits color output
➢
If the input is 10-bit signal and the output display device can support 10-bit output, user can set 10-bit
output mode through [Image Properties]
→
[Output Mode]
→
[ON]
➢
User can click [INFO] key on remote controller or front panel keypad to check input / output timing
result.
