Vmac VR70, Руководство по установке

Страница: 36 / 80

VMAC
– Vehicle Mounted Air Compressors
Toll Free: 1-888-241-2289
Fax: 1-250-740-3201
34
□
Remove the plastic hold down for the wiring harness on the
inside of the frame that interferes with the front bracket mount
bolt. Secure the wiring harness with supplied P-clamp onto back
of the mount bolts.
□
Bolt battery box mount in place as shown in Figure 3.22.
Remove the two cables that are attached to the supplied
battery box, and discard as they are not used in this
application.
□
Place battery in battery box and secure with supplied battery
hold down clamp.
Do not connect battery at this point and do
not lift battery up onto battery box mount at this point!
In some applications/industries it is preferable to keep the
bottom and frame of the truck clear of additional
components and, in those cases it is acceptable to relocate
the battery to a better location on or in the service body of a
truck, instead of onto the frame rail. See below:
□
VMAC cannot list or approve all the possible alternative battery
locations. It is up to the installer to follow safe/best practices.
VMAC will not warranty any improperly installed battery
boxes and/or cables or any failures relating to the
installation.
□
The installer must use best practices when routing the battery
cables, and must ensure that the function of the vehicle's
electronics, and other systems, are not adversely affected by the
location of the battery and the cables.
Do NOT attach the
ground wire to the frame. It MUST be connected to the same
point as the OEM ground wire or to the location shown in
the installation manual.
If there are specific questions
regarding the routing of the cables, please contact the Ford
Truck Body Builder Advisory Service at:
www.fleet.ford.com/truckbbas/