The red dot comes into focus when you view infinity.
3) Position the red dot by using the fine adjustments, which can move the finder in vertical
and horizontal directions independently. Place the target and the red dot so they overlap
each other.
4) After you finish the alignment, turn off the red dot by turning the brightness dial
counter-clockwise until it clicks.
Now the XY Dot Finder is ready for use. Turn on the red dot when you begin your observing
session.
Do not force the brightness dial. This may damage your adjustments for alignment.
Replacing the Battery
The XY Dot Finder comes with the CR2032 battery.
1) Make sure that the brightness dial is in off position. Open the top battery container cover
by turning counter-clockwise while holding down the brightness dial as shown in the figure 1
right.
