VITO PRO-POWER VIBE1050A, Инструкция по эксплуатации

Страница: 30 / 47

30
ASSEMBLY INSTRUCTIONS
Auxiliary handle assembly
The position of the auxiliary handle (14) can be adjusted
to ensure a safe working posture and with little fatigue
for the user.
1. Place the ring of the auxiliary handle on the drill by
the side of the quick bushing (1);
2. Adjust the auxiliary handle to the desired position and
tighten the handle by turning the fixing screw (15);
3. To remove the auxiliary handle, loosen the fixing
screw and remove it;
Depth stop assembly
To adjust the depth of the holes to be drilled, use the
depth stop (5).
1. Press the depth stop fixing (3) into the auxiliary
handle and insert the depth stop with the scale facing
outwards;
2. Adjust the depth stop until the distance between the
drill bit and the end of the depth stop corresponds to
the required drilling depth;
3. Release the fixing button;
Drills and accessories assembly and replacement
The impact drill can be used to perform drills and
tightening/loosening operations. For this drill and
tightening accessories are used.
Never assemble or change drill bits and accessories
while the drill is running. Always disconnect the drill
before performing these operations.
1. Hold the fixed base of the drill chuck adapter (2) with
one hand and loosen the drill chuck (1)
counterclockwise until the opening permits the drill or
accessory insert;
2. Insert the drill or accessory into the drill chuck
opening;
3. Hold the drill chuck adapter in one hand and tighten
the drill chuck clockwise until the drill or accessory is
properly fixed;
4. Make sure the chuck is tight using the provided
spanner;
5. To remove the drills or accessories, repeat point 1;
When using screwing bits s always use a universal bit
accessory.
OPERATING INSTRUCTIONS
The equipment is designed to perform impact drilling on
concrete, masonry and stone. It is also suitable for
drilling without impact on wood, metal, ceramic and
plastic.
Equipment’s with electronic control and
right/left rotation are also suitable for screwing.
When working with the impact drill, you should take
into consideration some care and procedures of use:
▪
Always use the auxiliary handle correctly placed and
hold the power tool with both hands. Losing the
control of the power tool may cause serious injuries;
▪
When working with loose or small pieces, use the
fixing devices to adjust them;
▪
Do not apply too much pressure against the working
piece/object. If the speed decreases abruptly, reduce
the pressure;
▪
When the tool gets stuck, turn off the equipment
immediately. Avoid the high reaction torques that
cause the backlash;
▪
Never leave the impact drill before the rotating part
is completely stopped;
▪
Always wear hear protection when using this type of
equipment. Exposure to loud noises may cause
hearing loss;
▪
Make sure the power cord is always behind the
machine while operating with it;
▪
Turn off the machine in case of:
- Spark and/or smoke formation in the carbon brushes;
- Lubricant leaking through the vent grid;
- Damages in the impact drill ’s housing;
- Damages in the “ON/OFF” switch ;
- Smoke or burnt smell appearance;