ENVI Series: VTC-IR40-N
91
If entire SD information is showing “-NONE-” this means SD card is not formatted, in this case click
back button followed by clicking SD Status & Format
Click on “1
st
SD” and the following screen will be displayed
Read format option on screen and then click Partition and Formata pop up screen will display
asking if you want to do a “Partition and formatting” click OK to continue or Cancel to stop. After
clicking OK the following screen will be displayed
Note: Be sure to turn off the device before installing a SD card. Otherwise, the SD card
may become defective. Always check the recommended type of SD card because
non-conforming SD cards can cause abnormal behavior of the system.
Содержание VTC-IR40-N
