Vitek VT-NV1600P, Руководство пользователя, Страница: 35 / 100

VT-NV Series – On Cue IP
34
TYPE: You can select AUTO, MANUAL or RTSP to make a connection between the NVR
and the IP Camera.
! AUTO: When you try to make a connection between IP Camera and NVR through peer
to peer by using the built in HUB, user can use this menu.
# If the IP camera is connected to NVR through Peer to Peer connection, The Default IP address will be allocated
192.168.172.101 ~ 104(4ch) / 192.168.172.101 ~ 108(8 & 16ch) automatically.
# In case of using "Auto" connection with IP camera, NVR changes and saves default value of IP camera in ID,
Password, RTSP Port, HTTP port, HTTP type)
# If the USER ID and password of the IP camera is not the default value, the NVR cannot change the configuration
of the IP camera in "Auto" connection mode.
#
If the configured value of USER ID and password of the IP camera is different than the default value, you need to
assign the right value by using the "Detail" menu.
If the message above does not appear, please check camera power and connection to the NVR
!
MANUAL: When making a connection between IP cameras and the NVR using
cameras already installed, you can use this menu.
# In case of "Manual" connection with IP camera, you can make a connection through the Ethernet (WAN) or Local
(LAN) port.
# ETHERNET: Select Ethernet for the camera connection through Ethernet (WAN) port.
# LOCAL: Select Local for the camera connection through Local (LAN) port.
# CANCEL: Cancel the manual connection.
The IP range of Local or Ethernet PORT for the connection between IP cameras and
NVR should be same when both are on the same network.
# Ex) if the IP of the ETHERNET PORT is 192.168.123.xxx, the IP address of the IP camera should be
192.168.123.xxx.
# Ex) if the IP of the LOCAL PORT is 192.168.123.xxx, the IP address of the IP camera should be 192.168.123.xxx.
# When making a connection between the NVR and IP cameras in manual mode, you must use ‘Detail menu