Vitek VT-8340, Инструкция по эксплуатации, Страница: 4 / 28

4
ENGLISH
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
• This unit is not intended for usage by children.
Place the unit out of reach of children during
operation and cooling down.
•
The unit is not intended for usage by physi-
cally or mentally disabled persons (including
children) or by persons lacking experience or
knowledge if they are not under supervision of
a person who is responsible for their safety or
if they are not instructed by this person on the
usage of the unit.
•
Do not use the unit if the power plug or the
power cord is damaged. If the power cord is
damaged, it should be replaced by the manu-
facturer, maintenance service or similar quali-
fied personnel to avoid danger.
•
Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction is
detected or after it was dropped, unplug the unit
and apply to any authorized service center from
the contact address list given in the warranty
certificate and on the website www.vitek.ru.
• Transport the unit in the original package only.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature keep it for at least three hours
at room temperature before switching on.
• Unpack the iron; remove the protection from
the soleplate (13), if any.
• Check the unit for damages, do not use the
iron in case of damages.
•
Before switching the iron on, make sure that
your home mains voltage corresponds to the
iron operating voltage.
• The unit is intended for operation with AC
system and 50 Hz or 60 Hz frequency, the
unit does not need any additional settings
for operating with the required nominal fre-
quency.
•
There may be water residue in the tank, this
is normal, as the iron has undergone factory
quality control.
Note: While the first switching on the heating
element of the iron burns, therefore occurrence
of foreign smell and a small amount of smoke is
possible, it is normal.
WATER SELECTION
You can use tap water to fill the water tank (10).
If tap water is hard, use distilled or demin-
eralized water, this will prolong service life
of the iron.
Note: Do not fill the water tank (10) with scented
liquids, vinegar, starch solution, descaling
reagents, chemical agents etc.
FILLING THE WATER TANK
Before filling the iron with water, make sure that
it is unplugged.
• Set the continuous steam supply knob (3) to
the position
– steam supply is off.
• Open the lid (2) and pour water into the water
tank (10) using the beaker (14) and then close
the lid (2) tight.
Note:
•
Do not pour water over the «MAX» mark (12).
•
If you need to refill water during ironing,
always switch the iron off first and unplug it.
•
After you finish ironing, switch the iron off,
wait until it cools down completely, then open
the water inlet lid (2), turn over the iron and
pour out the remaining water.
IRONING TEMPERATURE
Instead of the habitual temperature control knob,
this iron model uses the Smart Sense technology
determining the optimal combination of temper-
ature and the required amount of steam for any
fabric allowing ironing.
Before operation, test the heated iron on a piece
of cloth to be sure that the iron soleplate (13) and
the water tank (10) are clean.
•
If the item label is marked with the symbol ,
do not iron the item.
•
Corduroy and other fabrics that become
glossy quickly should be ironed strictly in
one direction (in the direction of the pile) with
slight pressure.
•
To avoid appearance of glossy spots on syn-
thetic and silk fabrics, iron them backside.
IM VT-8340.indd 4 16.01.2019 17:27:55