ENGLISH
5
6. The temperature and humidity readings will appear on the display.
7. Switch from
°F to °C by pressing the
C/F
button.
After these remote sensor settings have been completed, it will begin to transmit
weather data once per minute.
•
If your meteorological station registers signals from neighboring sources, choose a
different house code.
•
Factory default settings: house code = 01, channel = 01
Step 2: Receiver settings
8. Remove the lid from the battery compartment and, ac-
cording to correct polarity, install two AA batteries. Close
the battery compartment lid.
SYNCHRONIZING THE OUTDOOR TEMPERATURE READING
Auto-detect function:
1. After installing batteries in the receiver, activate the auto-
detect function, which should take about 3 minutes.
2. During these 3 minutes, the receiver will emit an audible
signals and display it once received the data from sensors.
•
If no signal is received during the 3 minutes, the outdoor
temperature will be displayed as “- - -”. If this happens,
try installing all of the units closer together, or in different
places; run the auto-detect function again – remove the
batteries from the receiver and then insert them again.
Manual learning function (Search for remote sensor signals):
If a new sensor is added or if the signal is lost from an existing sensor (the outdoor tem-
perature on the display will blink), the detection function must be completed again.
35391.indd 5
35391.indd 5
23.05.2006 17:08:51
23.05.2006 17:08:51
