ENGLISH
6
1. While in current time display mode, press
and hold the
Channel
button for 3 seconds.
2. An audible alert will be heard. This means
the detection function has been activated.
3. Each time a remote sensor is located, an
audible alert will be emitted and the “CH”
symbol will blink on the display.
4. Temperature data from the remote sensor
will be displayed on the LCD.
•
The auto-detect function is runs automatically for about 3 minutes.
•
If the detection function finished unsuccessfully, make sure that the remote sensors
are located within the operating range of the receiver or try moving them to a new
location.
SETTING THE TIME AND ALARM
Setting the time:
1 Press and hold the
Mode/Snooze
but-
ton for 3 seconds to enter the time settings
mode.
2 Set the desired hours by pressing the
Hour/+/Max
button.
3 Set the desired minutes by pressing the
Minute/-/Min
button.
4 Press the
Mode/Snooze
button to save the settings.
• Press the
Alarm/°C/°F
button to switch between 12-hour and 24-hour time for-
mats.
Setting the alarm:
5 Press the
Mode/Snooze
button to choose the Clock Alarm mode; the “
AL
” symbol
will appear on the display.
35391.indd 6
35391.indd 6
23.05.2006 17:08:51
23.05.2006 17:08:51
