6
ENGLISH
6
Lubricating the blade block
Before using the unit for the first time
remove the blade block (5) and lubricate it
with oil (9) (supplied with the unit).
–
If the universal attachment (6 or 7) is
installed, turn the cutting length adjust-
er (4) counterclockwise until bumping
and remove the universal attachment
(6 or 7) pulling upwards.
–
To remove the blade block place the
hair clipper with the blades up and
press on the upper part of the blade
block (5) with your thumb (pic. 1).
–
Apply 1 drop of the lubricating oil (9)
to the blades and the rear part of the
upper blade (pic. 2).
–
To install the blade block first insert its
lower part to the installation place and
then carefully press on the upper edge
of the blades until clicking to lock it.
–
Switch the hair clipper on by switch-
ing the power switch (3) to the position
“ON” having preliminary pressed the
lock button in the center of the power
switch (3). Let the hair clipper operate
for approximately 30 seconds to spread
the oil across the rubbing surfaces.
After that remove the surplus oil with a
dry cloth or a paper towel.
Notes:
–
Lubricate the blades after every use of
the hair clipper.
–
Use only the oil (9) supplied.
–
Do not use vegetable oil or oil with sol-
vents. Solvents will evaporate, leaving
thick grease that may slow down the
blades motion.
Universal attachment (6 or 7)
The universal attachment (6 or 7) has 10
fixed positions for cutting hair of different
length. It is shown on the scale on the cut-
ting length adjuster (4):
–
universal attachment (6) for hair
length – 1/2/3/4/5/6/7/8/9/10 mm.
–
universal attachment (7) for hair
length – 11/12/13/14/15/16/17/18/
19/20 mm.
–
Switch the unit off by setting the power
switch (3) to the position “OFF” before
installing, removing or changing the
universal attachment (6 or 7).
–
To install the universal attachment
(6 or 7) insert its guides into the cor-
responding grooves on both sides of
the hair clipper body and move the
attachment downwards until bumping
to lock it.
–
To adjust the cutting length turn the
adjuster (4) counter/clockwise to set
the required cutting length according
to the scale.
Warning:
Do not try to adjust the cutting
length with the adjuster (4) during the
unit operation, because when the power
switch (3) is set to the position «ON», the
adjuster (4) is blocked.
USING THE HAIR CLIPPER
–
For cordless use of the unit, charge the
battery fully following the recommenda-
tions above.
Note:
- during the hair clipper operation
the indicator (3) glows green.
Hair cutting
–
The hair should be clean and dry.
–
Before you start cutting hair switch
the hair clipper on having preliminary
pressed the lock button in the center
of the switch (3) and moving the power
switch (3) to the position “ON”.
–
Make sure that the hair clipper oper-
ates normally and the blades move
smoothly.
–
If there is excess oil on blades, remove
it with a dry cloth or a paper tissue.
–
Switch the unit off by setting the
switch (3) to the position «OFF», then
install the universal attachment (6 or 7).
IM VT-2584.indd 6
12.03.2019 17:37:21
