Vitek VT-2572 CR, Инструкция по эксплуатации

Страница: 6 / 28

ENGLISH
6
•
The scale (3) is situated on the reverse
side of the hair clipper body, so the select-
ed hair length is shown in a semicircular
window in the bottom part of the attach-
ment.
•
Switch the hair clipper off, setting the
power switch (2) to the «OFF» position.
•
Set the universal attachment (7) or (8),
insert the guides of the attachment into
the grooves on the body and slightly press
the attachment until a click.
•
You can select the position of the univer-
sal attachment (7) or (8) by pulling it up or
down according to the scale (3).
•
To remove the universal attachment (7) or
(8) pull the attachment upwards.
Step one
Depending on the required hair length,
select the position of the attachment accord-
ing to the scale (3). Switch the unit on by
setting the power switch (2) to the position
«ON». Hold the hair clipper with the blades
pointed upwards. Start cutting from the
beginning of the hair growth. Slowly move
the trimmer upwards. This way cut the head
back area at neck bottom and near the ears
(pic. 1, 2, 3).
Step two
Switch off the unit using the power switch
(2), then set the position for cutting longer
hair according to the scale (3) and con-
tinue cutting hair near the crown of the
head (pic.4).
Step 3 – cutting in the temples area
Switch off the unit, set the attachment to
the position for shorter hair and cut hair at
the temples. Then set the attachment to the
position for longer hair and continue cutting
towards the top of the head.
Step 4 – cutting the crown of the head
Using the necessary position, cut hair moving
from the head crown to the top, against the
direction of normal hair growth.
•
You can cut hair against and along the
direction of hair growth, but keep in mind
that the hair cut against the growth will
be shorter than the hair cut along the
growth.
•
Use the attachment (7) position 3 mm or
6 mm for very short haircut.
•
To leave a little longer hair use the follow-
ing attachment positions.
•
To leave longer hair, grip hair locks
between your fingers and cut the hair off
using the clipper (pic. 5).
•
You can use the comb: lift the hair locks
and cut them with the hair clipper above
the comb (pic. 6).
•
Always start cutting from the head back.
•
Comb the hair to reveal uneven locks.
Step 5 – the final part
At the final stage of the haircut, remove the
attachment (7) from the hair clipper, turn it
with the blades towards the hair and carefully
trim the hair on the temples and neck. Do not
press the clipper strongly, there is a danger
of injuries or cuts when open blades come in
contact with skin (pic. 7).
Cone-shaped haircut
Set the attachment to the necessary position
and start cutting from the back of the head
towards the crown. Cut the hair against the
direction of the growth, towards the crown,
and from the sides (pic. 8). To get a flat top
haircut, use the comb: lift the locks and cut
them along the comb. Comb the hair to reveal
uneven locks.
Hair thinning function
Hair thinning means making hair thinner.
The essence of hair thinning is in cutting
off separate locks at different height, which
allows achieving smooth transition between
locks of different length. Hair thinning is
performed at the final phase of hair cutting.
•
To extend the hair thinning comb, move
the lock (4) to the utmost left position.
To remove the hair thinning comb, move
the lock (4) to the utmost right position.
VT-2572_105 x148.indd 6 10.03.2016 14:07:18