6
ENGLISH
«OFF» and remove the excessive oil with a paper napkin
or a dry cloth.
– Use the required attachment (3) position during hair
cutting. Depending on the attachment (3) position the
remaining hair length will be from 1 to 13 mm.
– Hair should be clean and dry during haircutting. The
best results of haircutting are attained if the hair is dry,
not wet.
– Seat the person so that his/her head is approximately at
your eye level, cover the person’s shoulders with a towel
and set hair with the comb.
– Always start cutting from the back of the head.
– You can cut hair against and along the direction of hair
growth, but keep in mind that the hair cut against the
growth will be shorter than the hair cut along the growth.
– To leave longer hair, take hair locks between your fin-
gers and cut it using the hair clipper.
– Always cut off little amount of hair at a time; you can
always return to the cut area again for additional cutting.
– Comb the hair to reveal uneven locks.
– You can lift the hair locks and cut them along the comb.
– Use scissors to trim hair.
– With time you will learn to model desired haircuts by
yourself.
CLEANING AND MAINTENANCE
– Switch the hair clipper off, setting the power switch (2)
to the “OFF” position.
– Remove the attachment (3) pulling upwards (pic. 1),
clean the inside and outside of the attachment (3) from
the cut hair, using the brush (6).
– You can wash the attachment (3) under a water jet, then
wipe it and dry out.
– Wipe the unit body with a soft slightly damp cloth. Do
not immerse the hair clipper body into water or any
other liquids.
– Never use solvents or abrasives to clean the hair clipper
body and the attachment (3).
Blade block
Attention! Do not wash the blade block (4) with water; use
rubbing alcohol to wash the blade block.
IM VT-2513.indd 6
10.07.2018 14:27:16
