5
ENGLISH
Notes:
– use only the “AA” batteries.
– do not use old and new batteries at the same time or dif-
ferent types of batteries.
– when the hair clipper operation is unstable, check the
batteries and replace them if necessary.
– do not recharge the batteries.
– strictly follow the polarity when installing the batteries.
– remove the batteries if you are not planning to use the
hair clipper for a long time.
– apply to specialized centers for further recycling of the
batteries.
– avoid the short circuit of the battery clips.
Lubricating oil
– To maintain the unit in good condition, the blade
block (4) needs to be lubricated after every use of
the unit.
Attention! Use only the lubricating oil (5) from the delivery
set.
DO NOT USE vegetable oil, fat, oil mixed with any solvents
for lubricating.
Solvents will evaporate, leaving thick grease that can slow
down the motion of the adjustable blade.
– Before installing the attachment, switch the unit
off by setting the switch (2) to the position «OFF».
– Install the attachment (3) to the installation place and
press on it (pic. 1).
– Depending on the desired remaining hair length from
1 to 13 mm set the attachment (3) to the correspond-
ing position.
– Set the switch (2) to the position «ON».
– After you finish using the unit, set the switch (2) to the
position «OFF».
Note: always switch the unit off during the intervals in
operation.
HAIR CUTTING GUIDES
– Before cutting hair switch the hair clipper on by setting the
switch (2) to the position «ON» and make sure that the hair
clipper operates normally and the blades move smoothly.
– If there is excess oil on the blades, switch the hair clip-
per off by setting the power switch (2) to the position
IM VT-2513.indd 5
10.07.2018 14:27:16
