7
ENGLISH
•
After brushing the bristles off, you can rinse both parts of
the shaving block (3, 4) and the shaving heads (2) with warm
water (fig. 5, 6).
•
After rinsing, dry or wipe all parts dry with a cloth to keep the
shaving heads dry.
•
Insert the removable part (3) back into the shaving block
body (4) and close the shaving block.
•
Install the shaving block back to its place, preliminarily
matching the ledge on the shaving block body (4) with the
groove in the installation place on the shaver body (5).
•
Put the protective cap (1) on the shaving heads (2).
•
Wipe the shaver body with a soft, slightly damp cloth and
then wipe it dry.
•
Do not use metal brushes and abrasive detergents or sol-
vents for cleaning.
•
It is recommended to clean the shaving head blades (2)
every two months.
You can find the shaving heads (2) removal and installation
procedure in the corresponding sections above
•
Switch the shaver off by pressing the on/off button (6), the
operation indicator (8) will go out.
•
Press the button to open the shaving block and detach the
removable part (3) (fig. 1).
•
Turn the frame lock counterclockwise and remove the frame
(fig. 2).
•
Remove each fixed shaving head mesh together with the blade.
•
Carefully remove the blades from the fixed meshes.
Note: Be careful when removing the fixed meshes, make sure
that the rotating blades have been installed into the same meshes
after cleaning, otherwise the noise may be higher and the shaving
quality affected.
•
Clean the blades and the fixed meshes with a brush (10).
•
Install the fixed meshes in the shaving block (3) removable
part making sure the meshes have been correctly installed.
•
Insert the blades into the fixed meshes following the instruc-
tions above.
•
Install the clamping frame, turn the frame lock clockwise
until fixing.
•
Insert the removable part (3) back into the shaving block
body (4) and close the shaving block.
•
Place the shaving block on the shaver body (5).
•
Put the protective cap (1) on the shaving heads (2).
Shaving heads lubrication
For an optimum shaver maintenance, lubricate each shaving head
with a lubricant drop periodically, any shaver or clipper lubricant
will be good. Apply a shaver lubricant on the outside of the shaving
heads and rub slightly with your finger. After turning the shaver on
for a short time, let the lubricant spread over the underside of the
Содержание VT-2365
Страница 1: ...Электрическая бритва VT 8262 Men shaver 4 10 18 25 33 41 VT 2365 ...
Страница 2: ...9 7 8 Рис 1 6 5 4 3 2 1 10 11 12 ...
Страница 3: ...Рис 2 Рис 3 Рис 4 Рис 5 Рис 6 ...