8
ENGLISH
•
Plug the power adapter into the mains
socket.
•
Set the vacuum cleaner on the charging
station, the contact points (12) on the vac-
uum cleaner should match the the contact
points (22) on the charging station. You will
hear a sound signal, and the line indicator (2)
will be flashing purple.
•
Wait until the line indicator (2) glows blue. The
battery charging is finished and the vacuum
cleaner is ready for operation.
Notes: - after battery charging, if no actions
are performed within 10 minutes, the vacuum
cleaner will automatically switch off, you will hear
two sound signals and the line indicator (2) illu-
mination will go out.
Wet floor cleaning
•
Press on the lock (15) downwards and remove
the dust bin.
•
Open the water inlet lid (14) and fill the water
tank (13) with water.
•
Turn over the vacuum cleaner and attach the
fabric attachment (39) with the stickers.
•
Install the dust bin into the vacuum cleaner
body until the lock (15) clicking, make sure
that the dust bin is fixed properly before using
the vacuum cleaner.
•
After wet room cleaning turn over the vacuum
cleaner and remove the fabric attachment (39),
wash it under a warm water jet and dry.
Notes:
–
if you are not going to use the vacuum cleaner
for a long time, pour the water out of the water
tank.
–
the water tank capacity is 270 ml.
Vacuum cleaner manual operation
•
Switch the vacuum cleaner on by pressing
and holding the start/stop button (1) «
» for
3 seconds. You will hear a sound signal and
the line indicator (2) will be flashing blue. The
vacuum cleaner is in the ready mode.
•
To switch the vacuum cleaner off press and
hold the start/stop button (1) «
» for 3 sec-
onds, you will hear a sound signal and the line
indicator (2) will go out.
Notes: - if you switch the vacuum cleaner on and
no actions are performed within 10 minutes, the
vacuum cleaner will automatically switch off, you
will hear two sound signals and the line indica-
tor (2) illumination will go out.
•
To set the necessary direction of the vac-
uum cleaner motion use the buttons (27) «
» on the remote control.
Automatic room cleaning mode
•
To switch the vacuum cleaner on in the
standby mode press and hold the start/stop
button (1) «
» for 3 seconds. You will hear a
sound signal and the line indicator (2) will be
IM VT-1804_2020.indd 8
4/21/20 2:05 PM
